Question PeakTrough EA - Only 1% DD!

Based on this information, we can think of a virtual breakeven...

 

Hi Luizinho I really appreciate your openness hopefully we will be successfult in developing this EA. I will try to do my own BT next week and maybe try a FT.

 

The Stop Buffer parameter does, it adds points in the buystop above order and the order sellstop below.
You can also place a negative value.

 

I understand.Thank you

 

This is perfect, 100% wins ...
Congratulations on your dedication and especially for sharing ...
Let it go!

I am now working on:
High spread protection based on average with adjustable parameters.
Get commission points automatically.

Towards the top

 

Nice.

 

This is my review for this thread:
very good!
 

Can you share your .set please ?

 

This is my review for this thread:
Its getting better and better everyday! thanks to Luizinho and SeizeTheDay for there time and effort to develop and enhancing the EA! Good luck to us and hoping for SUCCESS!

 

very nice result with 100% winning trade SeizeTheDay

 

Yeah But sorry DD it's not only 1 %, if you fair, you should make another TS for DD below 30%. one again It's fact. sorry if i don't like this TS anymore.

 

Luizinho you are developing an amazing thing my friend.
To do list, ideas...

%Risk calculation : Balance / (Average spread + average slippage + commission points)
Auto calculation of stop buffer based on average spread. For example if average spread is 5 sell stop is placed by 5 points top, buystop 5 points of bottom.
And the spread protection much appreciahed.

 

Test looks N/A but %100 reliable ducascopy data.

 

Trade protection by BreakEVEN.

The only and most important thing is spread protection for now.

Luizinho this is for you.

 

Here are my results, same settings like

Here are my results, same settings like you, but complete other results, date from tickstory
Where is mistake ?

 

You extracted the data from ducascopy wrong. Look post number 241, extract data as it is. Probably you extracted with 30 point freeze level. Break even can not be used. Or you extracted with internal spread, do not put spread. Set your own spread by testing.

 

Here you see my settings in ducascopy, I think ok ?

 

You are using 1:100 leverage. If so you must lower the risk. You are getting stop out.

 

9 point spread + 7 usd commission. Almost the same as reality. A little high risk 1:500 leverage.

 

Now use leverage 500, but very high risk